|
Energy Efficient Water Heating
A Taitron® Heat Pump is one of the most efficient methods known to heat water.
This is because electricity is not used to heat water directly but is only used to run a compressor, just like an air conditioner.
A Taitron® Heat Pump uses almost 75% less electricity than a conventional electric water heater!
Imagine the savings, especially if you use a* tank full or more of hot water every day.
With little modification the Taitron® Heat Pump can be used as a water chiller.
Independent University of Adelaide tests compared a Taitron® Heat Pump Water Heater with a conventional electric water heater.
The results: the conventional electric water heater consumed 11.4kWh of electricity to heat 230 litres of water. The Taitron® Heat Pump consumed only 2.5kWh.
During the tests, the electrical energy consumed by the Taitron® Heat Pump was a factor of 3.9 smaller than the electrical energy consumed by a conventional electric water heater.
Depending on electricity tariff and hot water usage the savings in energy costs will be significant.
A Taitron® heat pump also costs less to run than a gas water heater.**
So, you can enjoy significant energy savings and reduce the environmental cost at the sametime while the Taitron® Heat Pump, Water Heater pays for itself!
A Taitron® Heat Pump Water Heater can meet any of your hotwater needs
You name it, Taitron® Heat Pump Water Heaters provide hot water for any purpose.
The domestic heat pump water heater connects to single phase electricity supply and is complete with a built-in 200 litre stainless steel tank. Large enough for the average Family.
Taitron® Heat pump water heaters are also ideal for large domestic hot water needs in dormitories, nursing homes etc.
Taitron® Heat Pump Water Heaters are also ideal for other hot water needs, not just for great hot showers:
-
Enjoy a hot spa all year round for a fraction of your current heating costs
-
Heat a pool and extend its use into spring and autumn - even winter!
-
Provide plenty of hot water for under floor heating and warm cosy nights
-
Taitron® Heat Pump Water Heaters are not affected by chlorine
-
Taitron® Heat Pumps are quiet too, and generate very little noise
They look good and are unobtrusive. You won't even know they are there at all!
Taitron® Heat Pump Water Heaters heat water for spas, pools and under floor heating efficiently and economically.
Specifications
There are a number of models and capacities to choose from depending on the application and the volume of wafer to be heated.
All models are covered by a five year warranty on parts and labour.
|
Model
|
VPLV
400
|
VPLV
450
|
VPLV
700
|
VPLV
1000
|
VPLV
1200
|
VPLV
1500
|
|
Application
|
Domestic hot water
|
Spas, pools, under floor heating and large capacity hot water needs
|
|
Weight (kg)
|
105kg
|
106kg
|
119kg
|
150kg
|
220kg
|
220kg
|
|
Corrosion resistant coil
|
Yes
|
|
Stainless Steel 316 Storage Tank
|
200 Litres.
|
-
|
|
Power
|
2.1kW
|
2.5kW
|
2.3kW
|
2.8kW
|
3.6kW
|
4.4kW
|
|
Volts
|
240
|
415
|
|
Phase
|
1
|
3
|
|
Hertz
|
50
|
|
Noise level
|
30db – 60db
|
|
Refrigerant
|
R134a
|
|
Height
|
1230mm
|
|
Width
|
1100mm
|
1800mm
|
|
Depth
|
390mm
|
* Electricity used to heat 235 litres of water from approx 20°C to 55°C. In the tests the electrical energy consumption of the Taitron® Heat Pump is a factor of 3.9 smaller than the electrical energy consumption of the conventional resistive water heater.
** Savings based on natural gas consumption of 42 MJ to heat 200 litres of water from approximately 15"C to 55°C on a tariff of 1.97043 cents per MJ. Savings will vary depending on tariff and hot water usage.
All specifications are subject to alteration without notice.
Exclusive Australian and New Zealand distributor:
CSI Enterprises Pty Ltd
32 Clyde Street
Wingfield, South Australia 5013
Telephone: (08) 8244 0422
Mobile: 0430 101 799
Fax: (08) 8243 1655
|
